Page 1 of 1
VLAN tagging on WAN port
Posted: Wed Jul 21, 2021 5:54 am
by lollapalooza
Hello,
My ISP has changed the physical layer.
Now I have an ONT where to connect the ETH cable to.
ISP says that the WAN port of the router has to be tagged with a specific VLAN ID.
How do I set up the VLAN tagging for the WAN port?
Thanks a lot.
Re: VLAN tagging on WAN port
Posted: Wed Jul 21, 2021 8:47 am
by RomanHK
Gargoyle does not support VLANs, another option is to install OpenWrt and copy settings from it.
In most cases, the settings apply to the /etc/config/network file.
Re: VLAN tagging on WAN port
Posted: Wed Jul 21, 2021 8:51 am
by lollapalooza
Ok, thank you
Re: VLAN tagging on WAN port
Posted: Thu Jul 22, 2021 8:16 am
by pythonic
Another approach, if a hardware solution is acceptable, is to use a small smart switch to provide a VLAN tagged interface to the ONT connecting to an untagged interface to the router WAN port. Netgear and TP-Link both sell 5 port smart switches that I think can do this.
Re: VLAN tagging on WAN port
Posted: Thu Jul 22, 2021 8:22 am
by lollapalooza
Thanks for the suggestion...
Anyway in the meanwhile I tried to connect my Wireless router (which supporta VLAN tagging) to the ONT.
Unfortunately it does not work... after a few researches that seems to be a limitation from the ISP
Furthermore, I see that my Gargoyle router (that is an old WNDR3700v2) isn't enough powerful to support the new ISP speed of 1 Gbps
I believe I'll need to get rid of it for the moment
Re: VLAN tagging on WAN port
Posted: Fri Oct 01, 2021 10:01 pm
by -taz-
My ISP requests VLAN with tagging, how can I configure it?