Re: VLAN Network Config error - WNDR3800 running Gargoyle 1.11
Posted: Sun May 17, 2020 6:39 pm
Hi! Long term gargoyler, thanks so much!
Quick question.. I am about to get fibre to the curb NBN from Internode here in Aus. I too need VLAN2 on my WAN if. Currently on ADSL2 with the config below, configured via the GUI.
I am on a Archer C7 v2 on 1.12.0...
To me it looks like the WAN if is already tagged VLAN2 in the default config?
Thanks for you advice!
Quick question.. I am about to get fibre to the curb NBN from Internode here in Aus. I too need VLAN2 on my WAN if. Currently on ADSL2 with the config below, configured via the GUI.
I am on a Archer C7 v2 on 1.12.0...
To me it looks like the WAN if is already tagged VLAN2 in the default config?
Thanks for you advice!
Code: Select all
config interface 'loopback'
option ifname 'lo'
option proto 'static'
option ipaddr '127.0.0.1'
option netmask '255.0.0.0'
config globals 'globals'
option ula_prefix 'xxx:xxxx:xxx::/48'
config interface 'lan'
option type 'bridge'
option ifname 'eth1.1'
option proto 'static'
option netmask '255.255.255.0'
option ip6assign '60'
option ipaddr '192.168.200.1'
option dns '192.168.200.1'
config interface 'wan'
option ifname 'eth0.2'
option proto 'pppoe'
option username 'username@isp'
option password 'password'
option keepalive '3 5'
option ipv6 '0'
config interface 'wan6'
option ifname 'eth0.2'
option proto 'dhcpv6'
config switch
option name 'switch0'
option reset '1'
option enable_vlan '1'
config switch_vlan
option device 'switch0'
option vlan '1'
option ports '2 3 4 5 0t'
config switch_vlan
option device 'switch0'
option vlan '2'
option ports '1 6t'
config interface 'vpn'
option ifname 'tun0'
option proto 'none'
option defaultroute '0'
option peerdns '0'