Gargoyle Forum

Tried to revert to stock firmware and then back to Gargoyle.
Adding a new ddns service never ends.
The config looks ok (/etc/ddns_gargoyle.conf) , but it never update.
The force update option never ends.

dyndns / changeip / no-ip

Didn't test with previous builds. I have tried noip.com and dyndns. It just don't update and the force option does nothing. Mon May 14 14:02:07 2018 daemon.info ddns_gargoyle[4223]: Successfully retrieved local ip from url: http://www.tracemyip.org Mon May 14 14:02:07 2018 daemon.info ddns_gargoyle[...

Does anyone know how to install snmpd ?
Tried http://downloads.lede-project.org/snaps ... /packages/

snmpd does install but crashes.

Installed on WRT1200, upgraded from LEDE.
I can't get any dynamic network service to work.
Everything else is ok for now.

Thanks for the build !

Qos enabled, default settings, bandwidth adjusted in QOS settings.
I'll try to reset everything

Cpu load is low on archer C7, but I can't get more than 10 Mbits on a 100Mbits line. Previous build was ok(up to 85 Mbits).
Computer connected on Ethernet.
Same config...

anyone else having really bad performances with this build ?
Archer C7 and Wdr3600.

IPV6 still enabled, is this intentional ?

francisuk1989 wrote: Also with your wdr3600 do you get the 2.4GHz channels from 1-13 (if your European of course?) seem like v1.10.0 im only getting 1-11

Yes, only channels 1 to 11.

Edit: after turning off and on the Wifi, the router entered a reboot loop.

miniupnpd reports wrong external address for bandwidth monitoring (should reports local lan address 192.168.1.1) Can you please provide more detail? I could not replicate this. How are you testing it. I use Peakhour (https://peakhourapp.com) software on Mac to monitor my routers. It used to work wi...