Gargoyle Forum

Hi, I have used the commands given to successfully create 2 ssids with different passwords. Everything is working well, except that now I cannot view any bandwidth usage statistics by host name or ip like I was able to do before..anyone know what I can do? That's peculiar, because I'd been using th...

I've used various versions of Gargoyle and always set for a daily reboot, it reboots reliably every night.
1043ND 1.7 (Using the nov 30 build now)

So far, so good. Just unbricked my 1043nd into this release.
There's a problem managing the router with IE10 in Enhanced Protected Mode, though. The pop-ups don't contain data, for example if you edit a usb share. Works fine with EPM off...

Upgrading my 1043nd 1.7 from 1.5.7 and checking the "keep settings" yielded a brick. No sys light. Working on unbricking now...

EDIT: Guess not. My old craptop with a serial port is dead. 1043 is down for now.

I made the recommended changes a few days ago when I first upgraded my router to 1.5.7, but ran into a glitch today. I don't recall what I'd installed that day. When I tried to install the kmod-usb2 package, I get an error that I need kernel version 3.3.8-1-67c7..., but when I run 'uname -r' it tel...

After the RAID failure over at openwrt.org, package installs fail. In order to install packages, you can comment out the original src/gz that points to trunk and add the line below after replacing "YOUR ARCHITECTURE" with the appropriate info: src/gz attitude_adjustment http://downloads.op...

Dik0j wrote:
I need to know HOW IT WORKS ON 1043ND)))

Working fine on a 1043nd 1.7, save for the small glitches reported earlier in the thread, which you should've read prior to posting.

ZoomThru wrote: Tried to connect with ssh (putty) but couldn't connect and really don't have any real clue here what to do.

I know you mentioned the reset button doing nothing, but have you tried TFP?
http://wiki.openwrt.org/toh/netgear/wnd ... lsafe.mode

Seconding the above post on a 1043ND. For me, no rule gets added after saving the URL blocking rule (In both Firefox and IE10). Also: "Connected hosts" under "Hosts With Active Connections" shows a rather impressive list. Most of those only having one UDP connection. All those ho...

But keep in mind the qos configuration page WILL disappear again if you try to configure it.. It is hit and miss affair.. typically it will blank out if you use multiple window to configure the qos. Creating classes and rules are OK, just not editing in IE10. Firefox 14.01 works just fine for me. D...