Gargoyle Forum

No idea sorry mate.
Possibly best to ask at the openwrt forums at this stage

When you flash it automatically flashes the secondary flash. The router then boots into it.
The next time you flash it will also go to the alternative flash (the original primary).

So to get the same version on both, you need to flash twice in a row with the same image.

If it did get back to the GUI for you, the best bet is to reflash the firmware to get it all happy again, then restore your backup

Sounds like it's halfway between fail safe and broken lol.
Did you try the default password "password"

failsafe you should be able to just spam one of the buttons after you turn the device on until it enters the fail safe mode.

It takes a little while. Maybe 30 seconds.

Are you sure fail safe isn't working?
I've put my device into a completely unusable state and recovered it using fail safe.
I had a completely incompatible network config like your situation.

Try the power off power on 4 times method. It should switch to backup flash.

Details of router?

I've never experienced this.

Not sure about that. I think that file is used in the creation of some firewall rules maybe.

Nah I've never done it. Have no use for it.

Page: Status -> Connected Hosts Section: Connected Wireless Hosts I would be an improvement if bitrate values are separated by upload/download. It would be useful also to know which is the band (2.4 or 5 GHz) the devices are using; at the moment there's no way to know that. Had an opportunity to im...