Gargoyle Forum

Merry Christmas everyone!

I`m incredibly thankfull for this amazing project.

Looking forward to contribute a bit more in 2019.

Happy holidays!

Full port speed, or full port speed minus 14.4% QOS margin (If the automatic is on, you can specify up to 14.4% higher wan speed for Download QOS, thereby achieving full throughput, probably). These speeds are just really amazing on the 400mhz GLinet AR150. I wonder how many wifi clients it can hol...

I'm skeptical about these results... CPU utilization > 1 means that QoS just cannot work properly, imho. Your concern makes sense, at least in theory. In real life, I can play Starcrat II with insignificant increase in response times with loads of 3.XX and above. GUI is very unresponsive on theese ...

Hi everyone! Testing on an AR150 device over 500/500 link. Everything seems fine. Some speed test results: Default config after flash (QOS disabled/BWmon enabled): 94mbps/94mbps (hard limit by eth. top shows 0.70 cpu load with 10MBs download) QOS enabled (up and down, default rules)/ACC off/BWmon en...

So, after a lot of pain, found the answer: 1- Openning way for wireshark/TFTP in Windows firewall wasn't enough. Shutting windows firewall off entirely did the trick; 2- Brick reason is: WR941ND v5 is not supported by WR841ND v8 1.6.2 firmware. Used WR841ND v8 1.9.2 firmware instead. Working like a ...

Thank you, will take a deeper look into it.

Also, thanks a lot ispyisail for the great job at keeping Gargoyle!

Hello everyone! Longstory short, I bricked my TP-Link WR941ND V5, witch is running as a WR841ND V8. It was running Gargoyle 1.10.0 with minor stability issues, so I decided to "improve" it by downgrading to 1.6.2 WR841ND V8 sysupgrade image, and got a brick. Normal bricked status is only P...