Gargoyle Forum

If you want to divide LAN (LAN2) ports, use the VLAN functionality and use the firewall to control access to the NVR.
I've never used it so I can't help you better.

This configuration is not suitable for Gargoyle but for OpenWrt. A more robust setup is needed, which Gargoyle does not support.

https://www.gargoyle-router.com/phpbb/viewtopic.php?f=8&t=6989&p=28648#p28648 You can try it from a Polish colleague: If you have D-Link firmware: http://dl.eko.one.pl/gargoyle-pl/attitude_adjustment/ar71xx/gargoyle-1.6.2.2-ar71xx-dir-601-a1-squashfs-factory.bin If you already have Gargoyle ...

The DIR-859 A2 has no OpenWrt support ( https://openwrt.org/toh/hwdata/d-link/start ), so Gargoyle is not supported.

If you have d-link firmware, use factory: https://www.gargoyle-router.com/downloads/images/ar71xx/gargoyle_1.12.0-ar71xx-generic-dir-835-a1-squashfs-factory.bin If you already have another version of Gargoyle or OpenWrt, you will use sysupgrade: https://www.gargoyle-router.com/downloads/images/ar71x...

Some useful tips: - Both routers must be in "Gateway (default)" mode. - Router1 DHCP ON, Router2 DHCP OFF. - Connect routers only with Ethernet cable LAN1 to LAN1. - Do not connect the WAN port on router2. - Both routers must only have WiFi in AP mode (AP+WDS). - If you have the same WiFi ...

SirSWE wrote:Still showing 20hz and 40hz (lower or upper)

2.4Ghz is 40MHz maximum. Maybe you're confused with 5GHz (there's no lower or upper). https://en.wikipedia.org/wiki/List_of_WLAN_channels

rsbrux wrote:Please let me know if there is any diagnostic info which I should consult or post here.

Make sure the DHCP server is running over ssh: The must be running in router1 and must not be running in router2.

rsbrux wrote:I'm not sure what is meant by a "clean start"

Reset to default. Many people use the original saved configuration (backup) and this creates additional problems.

Yes, performance requirements in OpenWrt are increasing and so are requirements in Gargoyle. Everything is aging and there are no exceptions in electronics so: if you want speed on the old hardware, you have to sacrifice security and settle for a lower version of Gargoyle. Conversely, if you want to...

Beware of typos! (Router IP 192.163.0.3?).

As @Lantis says, there's really nothing to spoil if you plug it in correctly and select the correct IP address.

Go through it again with a clean configuration and it must work. In rare cases, the WAN port may not work, so always start with a LAN port.