Gargoyle Forum

It looked alright to me

Yes you must create a second bridge.
Your DHCP config looks wrong.
Take a full copy of the default dhcp 'lan' stanza, paste it again and change it to refer to 'lan2' for the interface. It will also need another name for the second (lan2 will suffice).

Well what have you tried? Can you share the config changes you've made? You will need to make the following changes: - Network - Establish a bridge device "brlan2_dev", including the eth devices you want. Remove it from the regular brlan_dev - Establish a new interface 'lan2' which uses br...

As for lack of email reply, I think there is an issue with the forum sending emails at the moment. I’ve asked Eric to look into it but have not heard anything back as yet.

Always start with the OpenWrt guide for installation. For your device there is no specific wiki page, but it does have a tech data page https://openwrt.org/toh/hwdata/ubiquiti/ubiquiti_unifi_nanohd For installation instructions it refers to the git commit https://git.openwrt.org/?p=openwrt/openwrt.g...

It’s available for download as of v1.14 as well.

1.15 is in the works.
I'll do my best to add basic vlan support to 1.15.

Yes that is fine

You missed the most important line which is what pythonic referred to.

Firmware/Device Compatibile:No. Config cannot be migrated from swconfig to DSA

The upgrade should run fine if you don’t preserve settings and force it.

alkhall wrote: ↑

Sat Jan 06, 2024 1:31 pm

Is TP-Link model AX6000 supported?

No, it is a Broadcom based device and therefore very unlikely to be worth supporting.