Gargoyle Forum

What is the command in terminal (Linux) to log into gargoyle in failsafe?
I’ve only used putty and winSCP but have not learned how to do it myself in CLI

I will use a raspberry pi 4 to correct my config using failsafe and terminal

Fixed it by configuring as gateway as both client and AP.

Fiber modem is set to 192.168.1.1
1.10 gargoyle is set to AP using ip 192.168.1.2
1.9x Repeater 192.168.2.1 connects to AP but has no internet.

Routing is default.

Can I winSCP or telnet to edit a file correcting this on the repeater?

Thanks

This works as it should.

Thanks.

I’m trying with Putty to backup most of a share_1 on /dev/sda1/ to the folder Backup on the second hard drive /dev/sdb1 Could do it with laptop but tried cp -pr /dev/sda1/share_1/* /dev/sdb1/Backup/* Says it is not a directory It tried /mnt/ for both, with and without the * Always comes back can’t s...

I've got same problem on 1.9.2 on a WNDR3800.

When I make restriction for specific ip, or for all except, it has no effect.

Haven't found solution

So my exroot USB storage is /dev/sda1 currently on the primary (only) partition on my only USB hard disk. If I put the USB drive through a powered USB 4 port hub instead of directly in my netgear wndr3800, what do I need to do so the exroot is read? Last attempt did not mount the drive. I'm trying t...

Same experience as April 8 torrent
tapper was right in that Enforce DHCP assignment breaks repeater if ticked.
I've tried many versions without success until reading tapper's comments on April 8 torrent.

Now it works but without ip control.
I'm happy though.

Thanks all for the great software!

Much appreciated

I'll try to copy paste too to get some more experience so I'll be less hopeless in the future.