Gargoyle Forum

After restarting the router( power off/on) it didn't respond anymore. Pffff i stay with 1.3.9...

Hi Eric, i tried the same simple procedure to upgrade my WRT54GL to the 1.3.11 version with the TFTP method and after that i changed some ip settings manually it finally respond now. I had always issues to try this with version 1.3.10, but now i change the settings and saving them and now it replies...

Hi, some update info, the bridge setup works for me for version 1.3.10 but the router setup not, the only thing i did was changing the ip address on the router and after reboot it didn't respond to this address. (192.168.1.65 instead of the default 192.168.1.1) But what is most strange is when i con...

Hi, right i mentioned this also before. I tried it also with entering the config manually instead of backup/restoring the config. I am now trying to fully reset the router and bridge with the factory firmware and retrying to install the version 1.3.10 and configuring it manually. I keep my results p...

Hi , did anyone tried installing the new version 1.3.10 onto linksys WRT54GL model? I tried it on two of these but finally reverted it again to version 1.3.9 due not working and both bricked them and needed to use the tftp procedure. My setup is a router and bridge , the router went unreachable afte...

Hi, thanks for the info, i justly tried the reflash with mini DDWRT and reflashed to gargoyle firmware. But the issue still remain the same. I also replaced one ntp address to the ip address 8.8.8.8 and i noticed the UTC time jumped again to UTC-8. I will try one of these days to swap the routers, t...

Hi , i tried resetting the bridge to defaults and reconfigured it. But it still does not update and goes after saving to the -8UTC time. Can you suggest me some other reset options? I only could reset the WRT54GL model thru the GUI of Gargoyle, the reset button on the back does not respond. I tried ...

Hi, tried to set the googles 8.8.8.8 ntp address but still it doesn't work. I also notice the time zone is always going back to UTC-8 instead of the selected one UTC+1. I will try soon to see if the WDS setup works for me. Thanks

I tried with the ip addresses but no result. I will test soon the wireless bridge/repeater WRT54GL as an gateway and putting it on the first place next to the modem. If it updates then i know for sure it is no hardware problem with the clock on the router itself. If somebody else has some new ideas ...

Hi, I have a setup of two linksys WRT54GL , one as router and the other one as wireless bridge/repeater configured to extend some wireless range where two computer are connected to. I noticed the time is not updated on the bridge(second wrt54gl) thru the ntp servers. I noticed this already on the fi...