Search found 12 matches

by Qinn
Sun Oct 29, 2017 7:35 am
Forum: General Discussion
Topic: Wireless bridge
Replies: 5
Views: 4736

Re: Wireless bridge

Reporting back. I upgraded to 1.10.0, but still no IP through DHCP for the client, strangely bridge got on Relay IP Address? Then I changed the wireless bridge to another AP2 and to my surprise the client got an IP? Then I looked for the difference between those 2 AP's and AP1 had no gateway into th...
by Qinn
Sat Oct 28, 2017 6:01 am
Forum: General Discussion
Topic: Wireless bridge
Replies: 5
Views: 4736

Re: Wireless bridge

Thanks Lantis and d3fz for your quick reply's. The TP-Link TL-WR841N/NDv8 has the following setup: For the bridge IP I have chosen IP address 172.16.0.1 (I am not using this private subnet anywhere). It joins an AP 192.168.5.10, which is connected through a switch to a router. I has a dhcp server th...
by Qinn
Fri Oct 27, 2017 11:32 am
Forum: General Discussion
Topic: Wireless bridge
Replies: 5
Views: 4736

Wireless bridge

Over the last couple years I used 3 very cheap, but stable TL-wr841Nv8 as wireless bridges (repeater disabled). The TL-wr841Nv8 got an IP (Gargoyle calls it the Bridge IP) that's outside the DHCP range of the router, but in the same subnet as it connects to (let's say 192.168.5.5). Now any device I ...
by Qinn
Fri Apr 10, 2015 8:43 am
Forum: Network / Wireless Issues
Topic: ArpNat
Replies: 2
Views: 3049

Re: ArpNat

uysiquebien wrote:DD-WRT has wireless bridge support with ARP NAT?
I'm not a dd-wrt dev but here it works.
by Qinn
Wed Apr 01, 2015 2:08 pm
Forum: Network / Wireless Issues
Topic: ArpNat
Replies: 2
Views: 3049

ArpNat

From what I've read Gargoyle should have this. But here a wireless bridge (atheros) which comnects to a AP (broadcom) doesn't give ip's on mac address from a router that's behind the wireless brige. The moment I replace Gargoyle with dd-wrt it works. Can anyone explain mel what I've missed. From wha...
by Qinn
Tue Mar 03, 2015 12:40 pm
Forum: General Discussion
Topic: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4
Replies: 6
Views: 4867

Re: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4

:oops: just after the second serial flash I saw that the image size of 1.7.1 was 200kb ....after I downloaded it again all was well so nothing is wrong with 1.7.1 for TP-Link WR841N v8.4
by Qinn
Tue Mar 03, 2015 11:48 am
Forum: General Discussion
Topic: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4
Replies: 6
Views: 4867

Re: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4

I used USB TTL converter and restored OpenWRT using http://wiki.openwrt.org/toh/tp-link/tl-wr841nd Then using LuCI I flashed it to Gargoyle 1.7.0 all went well . Then I Gargoyle 1.7.0 and upgraded to 1.7.1 with the try to preserve on and again it was bricked. So to my opinion there is something wron...
by Qinn
Sun Mar 01, 2015 6:46 am
Forum: General Discussion
Topic: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4
Replies: 6
Views: 4867

Re: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4

ispyisail wrote:failsafe reset
thnx for your reply but I tried it but that doesn't work. When I switch it on the power led gets on and after that all led's go on and off. Powering into failsafe (nice function btw) is gone.
by Qinn
Sat Feb 28, 2015 10:18 am
Forum: General Discussion
Topic: Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4
Replies: 6
Views: 4867

Upgrade 1.7.0 -> 1.7.1 Bricked TP-Link TL-WR841N ver 8.4

I bricked my TP-Link (as mentioned above) upgrading from 1.7.0. to 1.7.1 all led's are flashing on and off a few seconds apart, anyone be carefull.
by Qinn
Sat Apr 26, 2014 11:23 am
Forum: Hardware / Installation Issues
Topic: ASUS RT-N16
Replies: 19
Views: 22209

ASUS RT-N16

Hi has anyone had a successful Gargoyle firmware install in for the ASUS RT-N16 which has a Broadcom BCM4716 chip rev 1 pkg 10 chipset? I see there is a firmware called gargoyle_1.6.1-brcm47xx-squashfs.trx

Thnx