Gargoyle Forum

Lantis wrote: ↑

Wed Mar 18, 2026 8:47 pm

That sounds like your wan6 (or wan_6?) interface is going down.
Again should not be caused by any change in the bandwidth monitor fix. Let me know what you find.

Turns out this is an issue on ISP end. IPv6 over PPPoE runs well after requesting them to reset the line card.

What do you mean by that sorry I'm not following. Disappear from where? They disappear from WebUI -> Status -> Overview -> WAN IP Address and LAN IP Address. In my case, I should have an SLAAC for pppoe-wan as well as a delegated IPv6 address for br-lan. They won't exist a few days later. At that t...

Feedback appreciated. https://lantisproject.com/downloads/gargoylebuilds?dtf=eyJjIjpbMCwxXSwibyI6W1swLCJkZXNjIl0sWzEsImFzYyJdXSwicGwiOjEwLCJzIjpbWzAsIjEuMTUueF8yMDI2MDIyNCJdXX0 Hi Lantis, This version will make WAN/LAN IPv6 addresses disappear when using PPPoE connectivity. IPv6 addresses in fact a...

Hi Lantis,
OpenWrt has migrated to 24.10.5. Do you consider to upgrade Gargoyle 1.15.x accordingly? Merry Xmas and thanks.

Lantis wrote: ↑

Fri Oct 24, 2025 12:12 am

A new build has been posted which encompasses all the fixes raised in the thread recently with quotas. Many thanks to those who assisted with testing (particularly to @rg66)!

Thanks Lantis. New build works well for me. You may update download link in the first post as it still points to 20250803.

Lantis wrote: ↑

Fri Aug 08, 2025 6:33 pm

It has probably gone into coexistence mode.
viewtopic.php?p=36846&hilit=Noscan#p36846

Very informative and useful. Thanks Lantis.

Hi Lantis, Please check below iwinfo at run time and the Wi-Fi configuration. 2.4GHz is set to channel width: 40MHz 2nd chan. below but iwinfo reports HT mode: HT20 . Shouldn't it be HT40? I'm running 1.15.X (Built 20250803-0103 git@6f4f44fb). Thanks. iwinfo phy0-ap0 ESSID: "MyWRT" Access ...

Checking the logs on your device, and the output of “iwinfo” can verify on your end. Thanks Lantis. Will check the primary channel with iwinfo next time router is rebooted. Current iwinfo shows 149 is the channel as expected. P.S. Same Windows client never experiences channel 153 when router is run...

Hi Lantis, On 1.15.x/OpenWrt 24.10 firmware I find something strange with 5GHz Wi-Fi. Below is a partial setting in my /etc/config/wireless. config wifi-device 'radio0' option type 'mac80211' option path 'soc/soc:pcie/pci0000:00/0000:00:01.0/0000:01:00.0' option band '5g' option channel '149' option...

The WRT3200ACM is still a powerful device, but it has wifi issues and the driver development was abandoned. It’s ok most of the time, but in certain use cases it can be a poor experience. Can you please describe in short what the Wi-fi issue is and which specific use case it becomes poor? I would r...