Gargoyle Forum

http://wiki.openwrt.org/toh/tp-link/tl-wdr7500 For the Archer C7 v1.x 5GHz 802.11a/n/ac functionality is not supported, and likely will never be, since support for the AR1A (v1) variant of QCA9880 chip is not included in the open source ath10k driver. The Archer C7 v2.x uses the BR4A (v2) variant wh...

re: This post ispyisail, not trying to nag, but do you have any input about 5ghz and dual band support? I still haven't been able to get it to work. Thanks. http://wiki.openwrt.org/toh/tp-link/tl-wdr7500 For the Archer C7 v1.x 5GHz 802.11a/n/ac functionality is not supported, and likely will never ...

A Motorola Moto G 1st gen has once lost wireless connection and displayed: temporarily avoiding poor connection I encountered the same issue with OpenWrt Barrier Breaker 14.07 constantly so I flashed back to OpenWrt Attitude Adjustment 12.09. Fortunately it has only been an appeared once with Gargoy...

Successfully flashed a TL-WDR4300 v1.0 from Gargoyle-ispy 2014-December-25 to Gargoyle-ispy 2015-January-02 without preserving settings. As per usual used failsafe+firstboot after flash. No issue this far, I didn't have any wireless issues with Gargoyle-ispy 2014-December-25 so hopefully Gargoyle-is...

Iv just reverted back to ddwrt on my wr741nd because i couldn't find how to change to my country in Wifi and enable channel 13 for my ISP AP. And some partial MAC characters in Wifi Scan beside SSID and Power? You could try http://luci.subsignal.org/~jow/reghack/README.txt Gargoyle is based on Open...

However, while this will be an official release, it will be in a new "experimental" branch. It should be fairly stable, but it's not going to be an official "stable" branch. Smart move IMO as the original release build of Barrier Breaking does have some issues that will hopefull...

omiez wrote:Is it a Must to enter failsafe to make firstboot or is there any other method to do a clean install ?

Tnx

Using firstboot is the equivalent of a factory reset, generally not necessary but I prefer to start with a clean slate to reduce the potential for issues.

Upped a TL-WDR4300 v1.0 from Gargoyle-ispy 2014-December-17 to Gargoyle-ispy 2014-December-24 without issue, post flash triggered failsafe mode then firstboot. No issues so far but I've only had the unit up for an hour. Will let you know if I run into any issues. Thanks for the builds ispyisail. I h...

Like OpenWRT Barrier Breaking 14.07 wireless is sometimes unresponsive using 20MHz, WPA2 PSK and various channels. OpenWRT Barrier Breaking 14.07 with some mobiles would loose ability to connect to AP after a while claiming poor signal, have yet to have that appear with Gargoyle-ispy 2014-December-...

Flashed a TP-LINK TL-WDR4300 v1.0 to Gargoyle-ispy 2014-December-17 followed by failsafe mode and using firstboot to ensure no invalid/old settings data is present and causing issues. Like OpenWRT Barrier Breaking 14.07 wireless is sometimes unresponsive using 20MHz, WPA2 PSK and various channels. O...