Gargoyle Forum

- 2.4Ghz Wireless will not use the extra channels if set to any of the 40Mhz options, but keeps working in 20Mhz mode. Even when no overlapping or only 1 overlapping networks exist. - 5Ghz Wireless will not work unless channel width is set to 20Mhz. Most likely a regulatory problem. To dig deeper w...

Sorry, I do not know where should I put these plugins on the router as previously I only specified plugin path and installen them using UI. Thanks. Download Putty and WinSCP - Find the folder built\[YouModel]\ on the download for this build, there you will find the plugins - Open WinSCP, select SCP...

Hi, Just tested this build in a C7 v2, clean install. First of all thanks for the hard work on this amazing firmware. I see the following problems or special considerations (I can help debug if needed): - 2.4Ghz Wireless will not use the extra channels if set to any of the 40Mhz options, but keeps w...

Gonna resurrect the thread again... Just installed Gargaoyle to WRT320N coming from DD-WRT, just flashed the generic broadcom image gargoyle_1.9.0-brcm47xx-generic-squashfs.trx Since OpenWRT added support for it last year I thought it should work and it did :P Haven't tested it thoroughly but all se...

Just flashed it to my WDR4300 v1.7, I was having a lot of Wifi performance issues in 1.6.2, this new version has been working really well for the last 8 hours, no wifi drops or slow downs.

Nice Work

Hi, Thanks GoUser for your collaboration. Including the commands in firewall.user does not work, after a lot of testing I realized that even when the commands in firewall.user are executed during the router or firewall start-up the rules are rewritten after its executed when the router is starting u...

Hi, Great info, I was a DD-WRT user and I did use the "Exempt" class to do what is described in this post and I was looking for a way to do the same in Gargoyle. I have just tried the command iptables -t mangle -R qos_ingress 2 -s ! 10.0.0.0/8 -j IMQ --todev 0 , replacing the IP address/Ma...

The hardware is closer between DIR-600 and DIR-615 E4 than DIR-615 C1

You can check: http://wiki.openwrt.org/toh/d-link/dir- ... 2.revision

DIR-615 C1 has Atheros AR9130 CPU / AR9102 Radio

DIR-600 / DIR-615 both have Atheros AR7240 CPU and AR9285 / AR9287 radios.

Reverting back to stock and then flashing to Gargoyle with Factory image is the way I did it, for me it seems better

If I'm not mistaken the DIR-600 B is Ralink chipset, so it will not work, I would go to DD-WRT (Build 15962) for that hardware since Gargoyle doesn't have a build that supports Ralink.