Gargoyle Forum

I have a similar issue with 2.4G WIFI. What appears to happen is that the WIFI signal is still there but the authentication is lost (I am unsure if the WIFI signal drops out then comes back). Clients trying to connect get "Invalid password" even though the password is correct. This only ha...

I’m with TPG. Had a bit of a rocky start with them but is has come good. I have one of the SamKnows boxes to monitor the speed and on average get around 93 Mbps down.

I've got it working now. According to your earlier info lantis, it seemed to me all that was missing with my initial problem was the '5t' on the vlan '1' ports definition. Having OpenWrt up and running I tried getting that to work by editing the /etc/config/network file, where you mentioned to repla...

Thanks Roman, Lantis I've gone the OpenWRT way and have this running now. I don't see where I can specify the VLAN ID for the WAN / WAN6 side though. In the WAN config I can set of of the following interfaces: Ethernet switch: eth0 Switch vlan: eth0.1 (lan) Ethernet adapter: eth1 (wan6) Custom: I ad...

The original config was this, with a single VLAN ID 1 on the LAN side. My aim is to get an additional VLAN ID 2 for the WAN side. config interface 'loopback' option ifname 'lo' option proto 'static' option ipaddr '127.0.0.1' option netmask '255.0.0.0' config globals 'globals' option ula_prefix 'fdee...

I have a Netgear WNDR3800 running Gargoyle version 1.11. In the network config file I am trying to set up a VLAN ID of 2 which is required for my ISP (they provided a router that needs a reboot every month and DHCP can't reserve more than 32 IP addresses). This needs to be done in the /etc/config/ne...