Gargoyle Forum

Could you please summarise what you've ended up installing/setting to get these results?

it works like this only activated with all

I would like to install some plugins that I also used on wrt1900acs v2 but I don't know what the command is for GL-MT6000, for wrt1900acs v2 I use this:
https://lantisproject.com/gargoyle_cust ... bu/default
https://lantisproject.com/gargoyle_cust ... elspecific

Hello all, @pythonic thanks for the guidance, it seems to work! :D There is no one to deal with integrating all this in default for gargoyle and of course to optimize? with Disable Bandwidth Monitor! https://ibb.co/hCgwzm2 https://ibb.co/Dp9gDbK https://ibb.co/QmXR3yJ https://ibb.co/DCZmL1C with Ban...

root@Gargoyle:~# service irqbalance Syntax: /etc/init.d/irqbalance [command] Available commands: start Start the service stop Stop the service restart Restart the service reload Reload configuration files (or restart if service does not implement reload) enable Enable service autostart disable Disa...

Are you using Gargoyle's QoS at all? No! https://ibb.co/C8Fyhh6 https://ibb.co/jTZ6ZKS https://ibb.co/SVC9BBw BusyBox v1.36.1 (2024-03-08 13:50:43 UTC) built-in shell (ash) ------------------------------------------------------------------ | _____ _ | | | __ \ | | | | | | \/ __ _ _ __ __ _ ___ _ _| ...

Hello all, I installed gargoyle on GL-MT6000, INTERNET 1Gbps, in the speed test on the wire it does not exceed 500Mbps Download and Uploud 890Mbps, Connect Via:PPPOE ipv6 dual stack, that's all Gargoyle is capable of, there are some incompatibilities? Disable Bandwidth Monitor, I reach up to 890/908...

Disable Bandwidth Monitor, I reach up to 890/908 Mbps download and 880/923 upload

/etc/init.d/bwmon_gargoyle stop
/etc/init.d/bwmon_gargoyle disable

I installed gargoyle on GL-MT6000, INTERNET 1Gbps, in the speed test on the wire it does not exceed 500Mbps Download and Uploud 890Mbps, Connect Via:PPPOE ipv6 dual stack, that's all Gargoyle is capable of, there are some incompatibilities?

Hello Lantis,
I see that you have compiled firmware for GL-MT6000, what is the installation procedure for gargoyle if you switch from the original firmware or from openwrt to Gargoyle?

https://lantisproject.com/gargoyle_cust ... /mediatek/

Hello all,

Can someone help me with an image for the GL-MT6000?

https://openwrt.org/toh/hwdata/gl.inet/ ... _gl-mt6000