Gargoyle Forum

I reset the router to defaults, then manually reconfigured with basic WAN/LAN/WiFi (WPA2) settings. Still same issue. Seem to reboot in less than 1 day under moderate/heavy use. It's became too disruptive, I've reverted to version 1.12, that's much more stable. I use to run 1.12 for months without r...

Is it possible to log to a USB drive?

Happened again today. I've been on WebEx for hours, the router's been rebooting every day after about 4 hours for the past 3 days.

Thanks.

Hi, My router rebooted twice in 2 days at about the same time of the day. Is there any log kept that I can check to see what had happened? I ssh onto the router but could not find a log file to look at. I'm using TP-Link Archer C7 v4 with Gaygoyle 1.13. The first time, I noticed I lost of internet c...

Yes you are right, it's the WNDR3700 v5 (mt7621-wndr3700v5).
WiFi is set to WPA2 PSK, not using WPA3.

More details: Windows Powershell: PS F:\Downloads\Linux> scp test@192.168.10.10:/u99/stage/linux/OracleLinux-R8-U5-Server-x86_64-dvd.iso . oraagent@c3po's password: OracleLinux-R8-U5-Server-x86_64-dvd.iso 44% 4492MB 11.3MB/s 08:23 ETA PS C:\> ping -t betagate Pinging betagate.local [192.168.10.1] wi...

Hi, I've just flashed a Netgear WNDR3800 v5 (128Mb RAM) with 1.13. I have a Linux Laptop connected to the Ethernet port on the router, I was copying a large file to a Windows 10 PC using SCP from the Linux Laptop. PC is connected via WiFi. Half a minute into the copy, I noticed: 1. Other computers a...

Hi, I've been using 1.12.0 for a while on Archer C7 v4, it worked well for months, but now, it's not able to render the Bandwidth Usage and B/W Distribution graphs. It shows title and graph grid line etc, but no graph. Tried rebooting, still comes up blank. Also very slow when on those pages. "...

Hi, I have installed 1.11.0 on TP-Link Archer C7 v2. I've forgotten the password. I tried to reset it to default by holding the WPS/reset button after power off/on. I held the button for nearly 10 seconds, all the leds went off and and came back on flashing, and rebooted. But after reboot, router di...

I used the GUI to configure the PPPoE first, then edited /etc/config/network.

It's working for me on the TL-WR841ND. Going to try and configure TL-WDR4300 for VLAN 10 now.

BTW, am getting 27Mb/s download speed, and 14Mb/s Upload.

Here is my config for a TL-WR841ND (v8) on Gargoyle 1.9.1 (don't like the GUI on the newer versions). I'm with Spark (NZ). On the Huawei router provided by Spark, it's preconfigured to use PPPoE so I tried to do the same on Gargoyle, but don't know if that is strictly required. Essentially I only ch...