Gargoyle Forum

You don’t mention your current 4g router, which in all likelihood is adequate as it will retain it’s OEM firmware when connected to another gargoyle gateway... I have a standard B315 LTE router connected from one of it’s LAN ports to an Archer C7 WAN port. C7 has Gargoyle 1.10.x set as a gateway and...

I have done similar with a satellite router and the AR150 behind that. Not sure if it is the double NAT or some other applied filter, but the only thing that is an issue is accessing the ISP admin/monitoring page - when needed I plug a PC directly into the ISP router temporarily. All other internet ...

I can confirm that I have just used the sysupgrade file from as far back as 1.9.2x - just flash it from the OEM page. I am currently running 1.10.x build 20180213 (I am getting so confident I just upgrade and retain config over wifi from a remote AP on an AV link - no-one should do this!!!). It is r...

I have had success with a couple of 3G usb sticks on my AR150. I did have one that was not recognized, but I think it was an older vodacom locked dongle...

You must be right, and I'm clearly not understanding your problem. I simply checked my two fields as you have them circled in red, and my time offset of 2H is correct in both, where yours is showing one at zero and the other offset by your 4H timezone....

been there, done that!

Another handy place to look is under Status -> Connection List. Here you will see the QOS service classes allocated. Your problem is likely to be how you are categorizing these classes.... But, screenshots are the best for us to be sure....

How about allocating a group/series of IP's to your tenant's devices, and then you can put all of them into a single quota... the linked example would set a shared quota to a range of 16 IP's from 192.168.1.48 to 192.168.1.63. In the DHCP setup you would set these 16 IPs' to the tenant's devices... ...

Im running 1.10.x 20171221 on an AR150 in South Africa +2H. I have almost identical time in both fields. PPPoE is reporting 9H18 vs Time of 9H20, which makes sense if PPPoE takes a minute or 2 to connect after boot....

Try the AR150. You can buy it here on the store. I got one from deal extreme. It appears to perform identically to my C7 on a 20/10mbit fibre line....