Gargoyle Forum

I installed Gargoyle on my WA850RE and it was working well for a while but I had a few problems so I decided to go back to stock firmware, I installed it through ssh and now after it finished upgrading all it does when connected to the electricity the power led powers up, and then all the leds power up and repeats (again power led then all leds), I don't know how to fix it, while all the leds power up it shows up on the PC as 10.0.0.138, did anyone have this problem before?
Any of you knows how to fix it?
Thanks in advance!

http://wiki.openwrt.org/toh/tp-link/tl-wa850re


long shot
http://wiki.openwrt.org/doc/howto/generic.failsafe

If all else fails
http://wiki.openwrt.org/doc/hardware/port.serial

Hi!

I've a problem with my WA850RE.
When i'm flashing with gargoyle firmwire for the first time i made a mistake and i upload the file: gargoyle_1.8.0-ar71xx-generic-tl-wa850re-v1-squashfs-sysupgrade.bin instead of gargoyle_1.8.0-ar71xx-generic-tl-wa850re-v1-squashfs-factory.bin .

Now i can't work with repeater. The configuration page doesn't appear and i can't see any wireless network .

Can someone helps me please?

Thanks.
Tiago

as posted above