Gargoyle Forum

Lantis,

I'm wondering what kind of performance I could expect on the WRT1900ACS with a few QoS rules enabled.

With Qos enabled, my Archer C7 drops to around 60Mb/s.
My internet link was recently upgraded to 150Mb/s so I have a problem...

It should be able to fully utilise your link.
Try it and let us know your outcome. It would be useful to others.

All good now flashed without a problem.

Thanks for the help

Lantis,

I've seen some refurbs ACS units around for not-unreasonable prices. If I pick one up I'll let you know how it does.

Nice. Lucky to get such a premium device at a good price.

Hi,
I recently installed 1.9.2. Everything works great, except no internet pass through with Wireless client bridge.

I change the router back to WNDR3700v4 and wireless client bridge is working ok.

Nothing change on client router.

Can anyone confirm the wireless client bridge working on WRT1900ACS?

Thanks

is the other router also running 1.9.2?

Lantis wrote:is the other router also running 1.9.2?

Thanks for replying so fast.
new main router WRT1900ACS on 1.9.2
old main router WNDR3700v4 on 1.8.1
client router TP4300 on 1.9.2

On client router, only LAN works, no internet.
Settings on WRT1900ACS and WNDR3700v4 are the same.

Also, not so imporant, the timezone on WRT1900ACS is wrong.

I will try flash 1.9.2 shelby-sysupgrade on WRT1900ACS and see if it works. Could be a bad flash.

If you're using the exact same settings between the two routers, be aware that the requirements for bridge settings changed between those two versions.

Set 1.9.2 up from scratch reading the fields carefully. If you need clarification, let me know

Set up for main router or client router?
I did setup main router (WRT1900ACS) from scratch. Every pc has internet access. Only the client router has no internet access.
I didn't change anything on the client router (TP4300) and it connects well to WNDR3700v4. Where is setting to enable client bridge on WRT1900ACS?