Page 2 of 2
Re: Need help setting up QoS for the first time.
Posted: Wed Dec 14, 2016 6:47 am
by Lantis
With that small a bandwidth you won't get a ping time you are satisfied with.
Gargoyle will do what it can to make it the best it can be, but 1mbps between 8 devices is just not enough. Set realistic expectations before starting and you won't be disappointed
Re: Need help setting up QoS for the first time.
Posted: Wed Dec 14, 2016 10:15 am
by pkm
JavaMachine wrote:Volaris wrote:your pings stay slow and download speeds split evenly between devices
In my case I have over 8 devices actively using Internet in my house.
And high speed internet in my country (Uzbekistan) is something above and beyond of imagination.
I have 1024 kb/s download and 1024 kb/s upload limit
For now I am using RTT for somehow utilizing my ping in Dota 2 & WoW and even with this sometimes I have to completely disable internet for others.
By following your instructions, will I get desired ping even other 8 devices are actively downloading/surfing internet?
Thanks in advance
I struggle with 3Mbps between 3 people. God help you sir.
Re: Need help setting up QoS for the first time.
Posted: Fri Jan 13, 2017 9:46 am
by Djago
Hi!
I have a not very good 6/1mbps cable connection.
My worst nightmare is my backups programs (Google Photos and Zoolz). I use audio streaming a lot (phones/tablet/PC/ChromeCast Audio). Do you think this setup will help me?
Regards,
Djago
Re: Need help setting up QoS for the first time.
Posted: Fri Jan 13, 2017 12:43 pm
by tapper
Djago wrote:Hi!
I have a not very good 6/1mbps cable connection.
My worst nightmare is my backups programs (Google Photos and Zoolz). I use audio streaming a lot (phones/tablet/PC/ChromeCast Audio). Do you think this setup will help me?
Regards,
Djago
Yes mate give it a shot and see how it goes. If it does not work then just reset.
Re: Need help setting up QoS for the first time.
Posted: Wed Mar 22, 2017 11:53 am
by oenone1974
thank you for your guide volaris , it helped me a lot
Re: Need help setting up QoS for the first time.
Posted: Sat Mar 25, 2017 7:53 am
by oenone1974
how do I check if what I have set is working ?
Re: Need help setting up QoS for the first time.
Posted: Sun Mar 26, 2017 2:06 pm
by Phil T
I have Xfinity 100/6 service and used the settings posted here. It seemed to work well on 9.2. But then I tried to tweet the settings to get my speed closer to my service settings. When I did I got locked into a reboot loop and had to do a factory reset. Got me out of the loop but could not connect to internet any longer. I also could not revert back to factory software using the Archer C7 V2 revert software I had used with DD-WRT.
Finally was able to revert back to factory using a Open-WRT revert software.
Looks like you have to really be careful using these settings.