Need help for my WZR-HP-G300NH

[yc3948]

I successfuly flashed my WZR-HP-G300NH today but it died after restore the configuration backup from my linksys WRT54GL. I tried to 30/30/30 but not working, and I also tried to reset by holding reset button for 10 secs also not working. Please help!

My WZR-HP-G300NH flashed gargoyle_1.4.1-ar71xx-wzr-hp-g300nh-squashfs-sysupgrade.bin

and my linksys WRT54GL flashed gargoyle_1.3.16-wrt54g-squashfs.bin

and the backup file is backup.tar.gz

Could you please let me know any solutions? Thanks very much.

[pbix]

How about reading the directions?

http://www.gargoyle-router.com/wiki/dok ... e_recovery

[yc3948]

Thx but not working too...

[DoesItMatter]

I successfuly flashed my WZR-HP-G300NH today but it died after restore the configuration backup from my linksys WRT54GL. I tried to 30/30/30 but not working, and I also tried to reset by holding reset button for 10 secs also not working. Please help!

BAD BAD BAD idea...

You must NEVER flash a different config backup from a different router.

The only way this could be used is if you were backing up
Identical Hardware model and revisions

I.E. backup from a Linksys WRT54G-TM and restore to WRT54G-TM

Since you restored a Broadcom config backup to an Atheros device,
you will have to go in via Serial console and reload this firmware:

gargoyle_1.4.1-ar71xx-wzr-hp-g300nh-squashfs-tftp.bin

TFTP that via Serial Console and you should be OK

http://www.dd-wrt.com/wiki/index.php/Bu ... -HP-G300NH

Check that page and links in the page for recovery help.