Bugs in GUI adding static route rule

[behappy]

With my half bridge modem I need to add the rules because of ARP problem
- route add -net 192.168.1.0 netmask 255.255.255.0 eth1
- route add default gw 192.168.1.1
but the upon rules aren't valid from the GUI, since the gw address 0.0.0.0 or aterisk (*) isn't allowable.

From Terminal (putty) using route command, no problem
Edit config network adding section route w. upon section, no problem

Current Static Routes:
Destination---------------------Interface------Gateway
192.168.1.0/255.255.255.0-wan-------------0.0.0.0
0.0.0.0/0.0.0.0----------------wan-------------192.168.1.1

I believe the error check is only existed from js or xml template. Where to find the right one for editing it?

Is anyone running in the same problem from GUI?

[mikers]

Just saw this after posting a question that is related - having the same problem with the gui. Trying to set up the gateway of 10.1.1.1, but cant use a destination and mask of 0.0.0.0.

Works when I do it through putty on the command line.

Where does the gui store this info - could edit that file and add the zeros...