web server not working

General discussion about Gargoyle, OpenWrt or anything else even remotely related to the project

Moderator: Moderators

Post Reply
atrac
Posts: 13
Joined: Sat Nov 02, 2019 9:26 am

web server not working

Post by atrac »

Hello
I am running Gargoyle PL 1.11.0.4 on a gl.inet mt399n-v2.
Everything was working perfectly, when I modified remote web access adding a https custom port.
Forgetting about the fact that I cannot still manage to reach the router from outside (could be a port forwarding problem of the external router), now I cannot reach the router by typing it's address in the browser inside the lan.
However, I can access it through ssh, so it's alive and connected, but it looks like the webserver is dead. What can I do? I do not know what to check next...

RomanHK
Posts: 794
Joined: Sat May 04, 2013 4:18 pm
Location: Czech Republik

Re: web server not working

Post by RomanHK »

You should deal with it in the Polish Forum https://eko.one.pl/forum/viewforum.php?id=18 ...

Edit the /etc/config/uhttpd file and fix the ports. Default configuration:
EDIT: Sorry :oops: , I opened the wrong router, which is based on OpenWrt. The configuration from Gargoyle points to @Lantis in the post below.
Last edited by RomanHK on Fri Feb 07, 2020 9:12 pm, edited 1 time in total.
Turris Omnia with OpenWrt 21.02 - Tested
Linksys WRT3200ACM with Gargoyle 1.13.x
TL-WR1043ND v2 with Gargoyle 1.10.0

http://gargoyle.romanhk.cz custom builds by gargoyle users

Lantis
Moderator
Posts: 6920
Joined: Mon Jan 05, 2015 5:33 am
Location: Australia

Re: web server not working

Post by Lantis »

If you follow above advice, please use the Gargoyle defaults, otherwise you'll make the problem worse (those aren't even close to working )
https://github.com/ericpaulbishop/gargo ... f.gargoyle
https://lantisproject.com/downloads/gargoylebuilds for the latest releases
Please be respectful when posting. I do this in my free time on a volunteer basis.

atrac
Posts: 13
Joined: Sat Nov 02, 2019 9:26 am

Re: web server not working

Post by atrac »

My fault! I touched the local https port, I was confusing that with the remote!

BTW, I still have problems from remote, I will open a new thread.

Post Reply