Remove Gargoyle N150R

[jd45321]

Hi,
I got some cheap On Networks N150R routers, thought I'd try adding Gargoyle since there was a image for it. It appears no settings will stay, so I would like to remove Gargoyle with Openwrt or original firmware. However, I can't figure out how. Any ideas how to get Gargoyle off of this router? Note, it is a clone of Netgear WNR612 v2


Thanks

[famewolf]

I don't have the specific answer however a similar issue cropped up in the openwrt forum for those routers and the image had to be made a tiny bit smaller so there would be space left to save the config. That may just involve changing a few of the config flags when compiling. Have you tried earlier versions of the firmware that have a smaller physical size? You might give that a shot before totally ruling gargoyle out.

[Volaris]

I was never able to get Gargoyle running on those routers. However, you could install OpenWRT - that's what I flashed on them.

[famewolf]

I got gargoyle on 3 of the on networks N150/Netgear WNR612 V2 models. They now provide a specific build which worked fine..I DID have to first install openwrt and then upgrade them to gargoyle as the .img didn't work right.

viewtopic.php?f=14&t=8946