Hey guys,
up until a day ago i was running 1.5.10 and if i remember correctly, i installed net-tools (via opkg) to enable setting arp entries manually using the "arp -s" command.
having upgraded to 1.5.11, i want to do this again, but now i cant seem to find the net-tools package in opkg.
ideas? has it been replaced? is there another way to gain this ability (arp -s) ?
thanks!
Jack
setting arp entries manually !
Moderator: Moderators
-
- Posts: 13
- Joined: Thu May 09, 2013 1:47 pm
Re: setting arp entries manually !
Hello !
no reply yet, hoping someone could point me in the right direction
thanks
no reply yet, hoping someone could point me in the right direction
thanks
-
- Posts: 13
- Joined: Thu May 09, 2013 1:47 pm
Re: setting arp entries manually !
What's going on here !
I used to be able to get some sort of reply within a few hours.
is the forum dead now? or is the question just not clear?
come on guys, help me out
Jack
I used to be able to get some sort of reply within a few hours.
is the forum dead now? or is the question just not clear?
come on guys, help me out
Jack
Re: setting arp entries manually !
Us Gargoyle developers have no connection or knowledge of the package you are referencing.
You should take this up over at OpenWRT.org or with the package maintainer.
You should take this up over at OpenWRT.org or with the package maintainer.
Linksys WRT1900ACv2
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM
Netgear WNDR3700v2
TP Link 1043ND v3
TP-Link TL-WDR3600 v1
Buffalo WZR-HP-G300NH2
WRT54G-TM