Version 1.5.9 - Plugins Interface

[powerlogy]

Keep up

[ispyisail]

update

http://www.gargoyle-router.com/phpbb/vi ... =14&t=4213

[ispyisail]

update

http://www.gargoyle-router.com/phpbb/vi ... =14&t=4218

[Krog]

HI

WR-741ND V4 -Version 1.5.9 it seems its working fine

in client+ap

the default dbm is set in 27 dbm i need put more low??

[trance89]

HI

WR-741ND V4 -Version 1.5.9 it seems its working fine

in client+ap

the default dbm is set in 27 dbm i need put more low??

i have a v2.4 741ND too and it's working fine with 1.5.9 as a wireless repeater for months now
27 dbm is the default value so leave it that way if you don't want smaller wifi coverage

[DoesItMatter]

HI

WR-741ND V4 -Version 1.5.9 it seems its working fine

in client+ap

the default dbm is set in 27 dbm i need put more low??

http://wireless.kernel.org/en/users/Documentation/iw

run the command

iw list

from the command line after you telnet/ssh into the router

Even though it shows 27dbm, the max output your router can
do is listed in that "iw list" command

[trance89]

mine (v2.4 rev) says this:

Frequencies:
* 2412 MHz [1] (27.0 dBm)
* 2417 MHz [2] (27.0 dBm)
* 2422 MHz [3] (27.0 dBm)
* 2427 MHz [4] (27.0 dBm)
* 2432 MHz [5] (27.0 dBm)
* 2437 MHz [6] (27.0 dBm)
* 2442 MHz [7] (27.0 dBm)
* 2447 MHz [8] (27.0 dBm)
* 2452 MHz [9] (27.0 dBm)
* 2457 MHz [10] (27.0 dBm)
* 2462 MHz [11] (27.0 dBm)
* 2467 MHz [12] (disabled)
* 2472 MHz [13] (disabled)
* 2484 MHz [14] (disabled)

[Krog]

thanks DoesItMatter i gona to see who use tenel

trance89 who you make that to see the info?

well if is the same router i think is safe the 27dbm

[DoesItMatter]

thanks DoesItMatter i gona to see who use tenel

trance89 who you make that to see the info?

well if is the same router i think is safe the 27dbm

https://dev.openwrt.org/ticket/10034

Read that ticket, all the way at the bottom

WR741ND has max output of 17dbm (+ 3dmb for default antenna)

Even though it may show 27dbm, the max it will output is 17dbm
because that is a limitation of the hardware.

IF you have a consumer router - it is highly unlikely it will go
over 20dbm = 100mw

There are some that will output 1/2watt = 27dbm - but those are rare
The more wattage you put out, the hotter the device will run

[Krog]

i read it

thanks DoesItMatter for the info

100mw is ok the router reach is awesome

and is working smooth