When i restart router with gargoyle 1.5.6 (tew-632brp), my wifi params have tx=150 rx=300. Params have good.
I turn off the computer. And I will enclose for few hours. Params are low tx=65 rx=130. I must turn off router , and on (with change wifi channel) to be good. What goin on
Code: Select all
root@Gargoyle:~# vi /etc/config/wireless
config 'wifi-device' 'radio0'
option 'type' 'mac80211'
option 'macaddr' '00:01:23:45:67:89'
list 'ht_capab' 'SHORT-GI-40'
list 'ht_capab' 'DSSS_CCK-40'
option 'htmode' 'HT40+'
option 'channel' '6'
option 'hwmode' '11ng'
config 'wifi-iface' 'ap_g'
option 'device' 'radio0'
option 'mode' 'ap'
option 'network' 'lan'
option 'ssid' 'Net'
option 'encryption' 'none'Code: Select all
Linux version 2.6.32.27 (eric@Osiris) (gcc version 4.3.3 (GCC) ) #2 Thu Jul 26 19:25:58 EDT 2012
prom: fw_arg0=00000006, fw_arg1=a1f83fb0, fw_arg2=a1f84450, fw_arg3=00000004
MyLoader: sysp=20000000, boardp=20000000, parts=80000008
bootconsole [early0] enabled
CPU revision is: 00019374 (MIPS 24Kc)
Atheros AR9130 rev 1, CPU:400.000 MHz, AHB:100.000 MHz, DDR:400.000 MHz
Determined physical RAM map:
memory: 02000000 @ 00000000 (usable)
Initrd not found or empty - disabling initrd
Zone PFN ranges:
Normal 0x00000000 -> 0x00002000
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00002000
On node 0 totalpages: 8192
free_area_init_node: node 0, pgdat 802cc310, node_mem_map 81000000
Normal zone: 64 pages used for memmap
Normal zone: 0 pages reserved
Normal zone: 8128 pages, LIFO batch:0
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 8128
Kernel command line: rootfstype=squashfs,yaffs,jffs2 noinitrd console=ttyS0,115200 board=DIR-615-C1 mtdparts=spi0.0:128k(u-boot)ro,64k(config)ro,896k(kernel),2944k(rootfs),64k(art)ro,3840k@0x30000(firmware)
PID hash table entries: 128 (order: -3, 512 bytes)
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Primary instruction cache 64kB, VIPT, 4-way, linesize 32 bytes.
Primary data cache 32kB, 4-way, VIPT, cache aliases, linesize 32 bytes
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 29348k/32768k available (2073k kernel code, 3420k reserved, 409k data, 152k init, 0k highmem)
SLUB: Genslabs=7, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Hierarchical RCU implementation.
NR_IRQS:56
Calibrating delay loop... 266.24 BogoMIPS (lpj=1331200)
Mount-cache hash table entries: 512
NET: Registered protocol family 16
MIPS: machine is D-Link DIR-615 rev. C1
bio: create slab <bio-0> at 0
Switching to clocksource MIPS
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 1024 (order: 1, 8192 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP reno registered
NET: Registered protocol family 1
squashfs: version 4.0 (2009/01/31) Phillip Lougher
Registering mini_fo version $Id$
JFFS2 version 2.2. (NAND) (SUMMARY) Š 2001-2006 Red Hat, Inc.
yaffs Jul 26 2012 19:25:26 Installing.
msgmni has been set to 57
io scheduler noop registered
io scheduler deadline registered (default)
Serial: 8250/16550 driver, 1 ports, IRQ sharing disabled
serial8250.0: ttyS0 at MMIO 0x18020000 (irq = 11) is a 16550A
console [ttyS0] enabled, bootconsole disabled
Atheros AR71xx SPI Controller driver version 0.2.4
m25p80 spi0.0: s25sl032a (4096 Kbytes)
6 cmdlinepart partitions found on MTD device spi0.0
Creating 6 MTD partitions on "spi0.0":
0x000000000000-0x000000020000 : "u-boot"
0x000000020000-0x000000030000 : "config"
0x000000030000-0x000000110000 : "kernel"
0x000000110000-0x0000003f0000 : "rootfs"
mtd: partition "rootfs" set to be root filesystem
mtd: partition "rootfs_data" created automatically, ofs=340000, len=B0000
0x000000340000-0x0000003f0000 : "rootfs_data"
0x0000003f0000-0x000000400000 : "art"
0x000000030000-0x0000003f0000 : "firmware"
ag71xx_mdio: probed
eth0: Atheros AG71xx at 0xb9000000, irq 4
eth0: AR8216 switch driver attached.
eth0: connected to PHY at ag71xx-mdio:00 [uid=004dd042, driver=Atheros AR8216/AR8316]
eth1: Atheros AG71xx at 0xba000000, irq 5
eth1: connected to PHY at ag71xx-mdio:04 [uid=004dd042, driver=Atheros AR8216/AR8316]
Atheros AR71xx hardware watchdog driver version 0.1.0
ar71xx-wdt: timeout=15 secs (max=42)
TCP westwood registered
NET: Registered protocol family 17
Bridge firewalling registered
802.1Q VLAN Support v1.8 Ben Greear <greearb@candelatech.com>
All bugs added by David S. Miller <davem@redhat.com>
VFS: Mounted root (squashfs filesystem) readonly on device 31:3.
Freeing unused kernel memory: 152k freed
Please be patient, while OpenWrt loads ...
input: gpio-buttons as /devices/platform/gpio-buttons/input/input0
Button Hotplug driver version 0.3.1
Registered led device: dir-615c1:orange:status
Registered led device: dir-615c1:blue:wps
Registered led device: dir-615c1:green:wan
Registered led device: dir-615c1:green:wancpu
Registered led device: dir-615c1:green:wlan
Registered led device: dir-615c1:green:status
Registered led device: dir-615c1:orange:wan
ar71xx: pll_reg 0xb8050014: 0x13000a44
eth0: link up (100Mbps/Full duplex)
mini_fo: using base directory: /
mini_fo: using storage directory: /overlay
eth0: link down
device eth0 entered promiscuous mode
ar71xx: pll_reg 0xb8050014: 0x13000a44
eth0: link up (100Mbps/Full duplex)
br-lan: port 1(eth0) entering forwarding state
Compat-wireless backport release: compat-wireless-2011-11-29
Backport based on wireless-testing.git master-2011-12-01
cfg80211: Calling CRDA to update world regulatory domain
ar71xx: pll_reg 0xb8050018: 0x13000a44
eth1: link up (100Mbps/Full duplex)
cfg80211: World regulatory domain updated:
cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (2457000 KHz - 2482000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211: (2474000 KHz - 2494000 KHz @ 20000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
ath: EEPROM regdomain: 0x0
ath: EEPROM indicates default country code should be used
ath: doing EEPROM country->regdmn map search
ath: country maps to regdmn code: 0x3a
ath: Country alpha2 being used: US
ath: Regpair used: 0x3a
ieee80211 phy0: Selected rate control algorithm 'minstrel_ht'
ieee80211 phy0: Atheros AR9100 MAC/BB Rev:7 AR2122 RF Rev:a1 mem=0xb80c0000, irq=2
cfg80211: Calling CRDA for country: US
PPP generic driver version 2.4.2
ip_tables: (C) 2000-2006 Netfilter Core Team
NET: Registered protocol family 24
nf_conntrack version 0.5.0 (460 buckets, 1840 max)
CONFIG_NF_CT_ACCT is deprecated and will be removed soon. Please use
nf_conntrack.acct=1 kernel parameter, acct=1 nf_conntrack module option or
sysctl net.netfilter.nf_conntrack_acct=1 to enable it.
cfg80211: Regulatory domain changed to country: US
cfg80211: (start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
cfg80211: (2402000 KHz - 2472000 KHz @ 40000 KHz), (300 mBi, 2700 mBm)
cfg80211: (5170000 KHz - 5250000 KHz @ 40000 KHz), (300 mBi, 1700 mBm)
cfg80211: (5250000 KHz - 5330000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5490000 KHz - 5600000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5650000 KHz - 5710000 KHz @ 40000 KHz), (300 mBi, 2000 mBm)
cfg80211: (5735000 KHz - 5835000 KHz @ 40000 KHz), (300 mBi, 3000 mBm)
xt_time: kernel timezone is -0000
Hooked IMQ after mangle on PREROUTING
Hooked IMQ after nat on POSTROUTING
IMQ driver loaded successfully.
ip_set version 4 loaded
Ebtables v2.0 registered
device wlan0 entered promiscuous mode
br-lan: port 2(wlan0) entering forwarding state
device wlan0 left promiscuous mode
br-lan: port 2(wlan0) entering disabled state
device wlan0 entered promiscuous mode
br-lan: port 2(wlan0) entering forwarding state
ipt_bandwidth: timezone shift of 120 minutes detected, adjusting
old minutes west=0, new minutes west=-120
ar71xx-wdt: enabling watchdog timer
IMQ driver unloaded successfully.
Hooked IMQ after mangle on INPUT
Hooked IMQ after mangle on FORWARD
IMQ driver loaded successfully.
br-lan: port 2(wlan0) entering disabled state
br-lan: port 1(eth0) entering disabled state
eth0: link down
device wlan0 left promiscuous mode
br-lan: port 2(wlan0) entering disabled state
device eth0 left promiscuous mode
br-lan: port 1(eth0) entering disabled state
eth1: link down
ar71xx: pll_reg 0xb8050014: 0x13000a44
eth0: link up (100Mbps/Full duplex)
eth0: link down
device eth0 entered promiscuous mode
ar71xx: pll_reg 0xb8050018: 0x13000a44
eth1: link up (100Mbps/Full duplex)
ar71xx: pll_reg 0xb8050014: 0x13000a44
eth0: link up (100Mbps/Full duplex)
br-lan: port 1(eth0) entering forwarding state
device wlan0 entered promiscuous mode
br-lan: port 2(wlan0) entering forwarding state
device wlan0 left promiscuous mode
br-lan: port 2(wlan0) entering disabled state
device wlan0 entered promiscuous mode
br-lan: port 2(wlan0) entering forwarding state
IMQ driver unloaded successfully.
Hooked IMQ after mangle on INPUT
Hooked IMQ after mangle on FORWARD
IMQ driver loaded successfully.
device wlan0 left promiscuous mode
br-lan: port 2(wlan0) entering disabled state
device wlan0 entered promiscuous mode
br-lan: port 2(wlan0) entering forwarding state
device wlan0 left promiscuous mode
br-lan: port 2(wlan0) entering disabled state
device wlan0 entered promiscuous mode
br-lan: port 2(wlan0) entering forwarding state
