if enable QoS, sirq too High!!

[linux_pro]

My device is D-LINK 825B1

AR7161 680Mhz.

QoS default ruls, sirq on the 25%-28% between.

ADSL 10Mb/s...

it normal??

thanks.

[mix]

Why do you think system irq requests of 25% are high? You want to see a high sirq, try copying a very large file between two wireless clients connected to you AP.

[pbix]

I am not aware of any table that can tell us what "Normal" is for your router.

You did not say what your upload speed was or what the test conditions are so your report will not be of much use to other owners of your router either. If you could add some more information perhaps others would be interested in your observations.

If your SIRQ is less than 30% what is the issue?

[linux_pro]

Why do you think system irq requests of 25% are high? You want to see a high sirq, try copying a very large file between two wireless clients connected to you AP.

thank you for your reply.

i know,but i user eth, not WiFi.

[linux_pro]

I am not aware of any table that can tell us what "Normal" is for your router.

You did not say what your upload speed was or what the test conditions are so your report will not be of much use to other owners of your router either. If you could add some more information perhaps others would be interested in your observations.

If your SIRQ is less than 30% what is the issue?

thank you for your reply.

----pppoe-| 10Mb

/----wan---------------\
|dir-825 b1 ar7161 680M |
\-----------LAN1,2,3,4-/

|---NAS---|
| Run BT |

On the DIR-825, iptable setting in the iptable-save.txt.tar.bz2.

if NAS has 10Mb download speed, DIR-825 Sirq on the 25%-28% between.

thanks.