Hello I am trying to install Gargoyle on my Netgear WNDR3700v2
I am using the file: gargoyle_1.5.8-ar71xx-generic-wndr3700v2-squashfs-factory.img but I get a message that the file is incorrect.
I am living in the Netherlands so file is good I think?
Does anyone now how to install or what can be the problem?
Thx,
Ronald
Hardwareversie WNDR3700v2
Firmwareversie V1.0.0.32
Taalversie interface V1.0.0.56
Operation Mode Router
install fail on WNDR3700v2
Moderator: Moderators
- DoesItMatter
- Moderator
- Posts: 1373
- Joined: Thu May 21, 2009 3:56 pm
Re: install fail on WNDR3700v2
Try 1.5.9 or 1.5.7
There were multiple different issues/glitches occurring with the
WNDR3700's and version 1.5.8
http://wiki.openwrt.org/toh/netgear/wnd ... .to.device
Follow that page to do the upgrade
You need to use the factory one to flash via TFTP
Once you have Gargoyle (which is OpenWRT underneath)
any future firmware upgrades use the sysupgrade version of firmware
There were multiple different issues/glitches occurring with the
WNDR3700's and version 1.5.8
http://wiki.openwrt.org/toh/netgear/wnd ... .to.device
Follow that page to do the upgrade
You need to use the factory one to flash via TFTP
Once you have Gargoyle (which is OpenWRT underneath)
any future firmware upgrades use the sysupgrade version of firmware
Soylent Green Is People!
2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400
2x Asus RT-N16 = Asus 3.0.0.4.374.43 Merlin
2x Buffalo WZR-HP-G300NH V1 A0D0 = Gargoyle 1.9.x / LEDE 17.01.x
2x Engenius - ESR900 Stock 1.4.0 / OpenWRT Trunk 49400