Hi all,
Loving the features of Gargoyle Barrier Breaker 1.7.0.
The trouble is, after initially inputting my settings, I can't then make any changes. What I mean is, I can make changes - for example adding an ip range for a new quota, but when I press save, it goes back to what I had before.
Not only that, and more alarmingly, it resets all the quotas used so far to zero.
Any ideas out there anyone?
Julian
TL-WR741N/ND v1 not updating settings
Moderator: Moderators
Re: TL-WR741N/ND v1 not updating settings
This issues is resolved in 1.7.1
Can you help someone else get Gargoyle up and running?
TL-WDR3600 : Gargoyle 1.9.0 : NBN FixedWireless
TL-WR1043ND-V2 : Gargoyle 1.8.0 : 3G Huawei E160E
TL-WDR3600 : Gargoyle 1.9.0 : NBN FixedWireless
TL-WR1043ND-V2 : Gargoyle 1.8.0 : 3G Huawei E160E
Re: TL-WR741N/ND v1 not updating settings
Thanks for the update.
Linksys WRT3200ACM
NETGEAR Nighthawk R7800
NETGEAR R6260
NETGEAR Nighthawk R7800
NETGEAR R6260
Re: TL-WR741N/ND v1 not updating settings
I did try 1.7.1 and the problem with that release was it kept dropping the WAN settings - wouldn't keep for longer than 30 seconds. I know I should have reported it, but I panicked to get my shared internet back up.nworbnhoj wrote:This issues is resolved in 1.7.1
Do we know if that issue has been resolved?
I note that Tapper has mentioned the same problem with his modem using 1.7.1 - how's that working out for you?
Re: TL-WR741N/ND v1 not updating settings
1.7.1 has been pretty stable for me over the last week. I have read reports of issues with the WAN dropping, but I have not experienced it (3G WAN). There has been some weirdness reported that I have seen.bigdooley wrote:how's that working out for you?
http://www.gargoyle-router.com/phpbb/vi ... 7&start=30
1.6.2 is the rock solid choice.
Can you help someone else get Gargoyle up and running?
TL-WDR3600 : Gargoyle 1.9.0 : NBN FixedWireless
TL-WR1043ND-V2 : Gargoyle 1.8.0 : 3G Huawei E160E
TL-WDR3600 : Gargoyle 1.9.0 : NBN FixedWireless
TL-WR1043ND-V2 : Gargoyle 1.8.0 : 3G Huawei E160E
Re: TL-WR741N/ND v1 not updating settings
I note that Tapper has mentioned the same problem with his modem using 1.7.1 - how's that working out for you?