Page 1 of 1

rollback to official Netgear firmware!

Posted: Wed Nov 16, 2011 8:13 pm
by angelsanges
hi all!

how i can go back to official Netgear firmware from gargoyle 1.5?

i am on a netgear 3700v2

thanks!

Re: rollback to official Netgear firmware!

Posted: Wed Nov 16, 2011 11:19 pm
by DoesItMatter
https://wiki.openwrt.org/toh/netgear/wndr3700

Everything you need should be on that page.

Pay attention to this:

Code: Select all

Information on the factory-standard NETGEAR firmware

The stock firmware is actually a modified version of an older OpenWRT release. NETGEAR has provided partial sources, but the firmware can be tricky to build.

Some instructions for building (and rooting around in) the default firmware can be found here. This may also be helpful in attempts to duplicate the proprietary firmware in the fully open-source OpenWRT distribution: 
So, you are really still running an upgraded stock firmware
if you are using OpenWRT / Gargoyle

Re: rollback to official Netgear firmware!

Posted: Thu Nov 17, 2011 1:56 am
by angelsanges
thanks! but i think that this is not the answer i was searching....

i am using gargoyle 1.5 now and i want to go back and install the official firmware. (because gargoyle does not have wireless scheduler)

So i want to try dd-wrt

Re: rollback to official Netgear firmware!

Posted: Thu Nov 17, 2011 4:12 am
by Urgje
angelsanges wrote:thanks! but i think that this is not the answer i was searching....

i am using gargoyle 1.5 now and i want to go back and install the official firmware. (because gargoyle does not have wireless scheduler)

So i want to try dd-wrt
Why restore the Netgear firmware first? Can't you go directly from Gargoyle to DD-WRT? I seem to remember that I did, some time ago.

Re: rollback to official Netgear firmware!

Posted: Thu Nov 17, 2011 4:55 am
by angelsanges
because i tried that without success.

system upgrade , selected ddwrt and clicked ok....nothing appened, only a text: upgrading router....and gargoyle is still on 3700

I do not hate gargoyle, i simpy need wireless scheduler (turn on/off on specified time)

Re: rollback to official Netgear firmware!

Posted: Thu Nov 17, 2011 5:06 am
by Adri
angelsanges wrote:because i tried that without success.

system upgrade , selected ddwrt and clicked ok....nothing appened, only a text: upgrading router....and gargoyle is still on 3700

I do not hate gargoyle, i simpy need wireless scheduler (turn on/off on specified time)
Turn off the router.
Turn it back on while pressing the little 'reset' button at the bottom.
Keep the button pressed for about 45-60 seconds, until the power light start blinking green.
Now the router is in 'recovery' mode and you can tftp the stock firmware image to it.
You'll have to give your PC a static address of 192.168.1.2.

Adri.

Re: rollback to official Netgear firmware!

Posted: Thu Nov 17, 2011 5:28 am
by angelsanges
oh ok! this is nice.
thank you very much!